Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The West University Place Owner’s Guide

Ghost Controls keypad and intercom repair in West University Place typically runs $145 to $385 installed, depending on whether we’re replacing the keypad, the intercom module, or both, and which Ghost Controls series your gate opener uses. We stock Ghost Controls-compatible keypads and intercom parts on our trucks, so most West University Place calls are completed the same day. The usual story we hear: the keypad stopped accepting the PIN, or the intercom has gone silent, or water got inside the housing after a Houston downpour and now the buttons do whatever they want. If the gate still opens from a remote or the hardwired button inside the house, the motor is fine and the failure is almost always in the keypad or intercom circuit itself, which is a parts-level repair, not a motor replacement.

Call (346) 375-5416

Key Takeaways:

• Ghost Controls keypad repair in West University Place: $145 to $385 installed, written price before we start.
• We stock Ghost Controls keypads, intercom modules, and wiring harnesses on the truck.
• If remotes still work, the keypad or intercom is the failed part, not the motor.
• Every repair includes a photo log of what was found and a written record of the part number installed.

Which Ghost Controls Models This Applies To

Ghost Controls has kept their wiring architecture fairly consistent across their lineup, which is good news for repair pricing. The keypads and intercom modules we replace in West University Place are usually from the AXS Series, the TSS1, or the older TDS2 openers, and the compatibility gotcha is the wire count: some Ghost Controls keypads run on a two-wire bus, while others need a four-wire home run back to the control board. If someone swaps in the wrong keypad without checking the harness, the gate either ignores the PIN entirely or triggers the board’s error cycle every third entry. We identify the part by the label on the back of the keypad housing and the wire count at the board before ordering anything. For the intercom side, Ghost Controls uses a proprietary audio module in most residential units, so we generally recommend an OEM module over an aftermarket equivalent when signal quality matters, like on a long driveway where the speaker output is already marginal. On the keypad side, a quality aftermarket keypad that matches the wire count and mounting footprint is usually fine and saves $40 to $70 over the OEM part. Adrian Vance spent his early years wiring commercial access-control panels in the Northeast, and that habit carries over: we match the wire count, the voltage draw, and the mounting pattern before we quote a part.

Signs Your Ghost Controls Keypad & Intercom Repair Is Failing

• Keypad accepts the PIN but the gate doesn’t move. The keypad’s relay is firing, but the signal isn’t reaching the control board. Usually a corroded wire splice at the gate, not a dead keypad, which is a $95 fix instead of a $250 part swap.
• Some buttons work, others don’t. Membrane keypads on Ghost Controls units fail one contact at a time as moisture creeps under the overlay. Once the #3 key or the * key dies, the whole keypad is on borrowed time.
• Intercom hums or crackles when you press Talk. The audio module is getting power but the microphone or speaker cone has degraded. On units mounted on the south-facing side of a West University Place driveway, the heat accelerates the foam surround breakdown inside the speaker.
• Gate opens on its own when it rains. Water intrusion in the keypad housing is shorting a contact closed. This is the one to address fast, because a gate that self-opens is a safety problem, not just an annoyance.
• The keypad backlight stays on or never lights at all. Constant-on means a failed LED driver drawing the battery down. No light at all usually means the keypad’s internal transformer circuit has quit, and that part is not field-reparable on Ghost Controls units.

Before

After

Replacement Cost & What’s Included

Here’s the honest price picture for Ghost Controls keypad and intercom work in West University Place:

• Keypad replacement (aftermarket, two-wire): $145 to $210 installed
• Keypad replacement (OEM Ghost Controls, four-wire): $210 to $285 installed
• Intercom module replacement: $185 to $310 installed, depending on series and wire run
• Both keypad and intercom, same visit: $320 to $385 installed
• Wire splice repair at the gate (no part needed): $85 to $120 installed

The range depends on which Ghost Controls series you have, whether the existing wiring is salvageable, and whether we’re matching an OEM part or a quality aftermarket equivalent. The price we quote is the price you pay, written down and handed to you before any work starts. That’s Haven Standard Clause 1, and we’ve done it on every job since 2014. The work carries our 365-Day Done Right Promise: if the repair isn’t right within a year, we make it right at no charge. You also get a photo log of what we found, what we replaced, and the exact part number installed, filed in your job record.

DIY or Call Us?

Low-voltage keypad wiring is not in the same danger class as high-tension springs or line-voltage electrical work, but there are two places where a West University Place homeowner can get into trouble on a Ghost Controls keypad or intercom repair. First, the control board on a Ghost Controls opener has exposed terminals carrying 12 to 24 volts DC, and crossing the wrong pair during a wiring attempt can smoke the board, which turns a $175 keypad job into a $400 board replacement. Second, the keypad housing has to be sealed properly against Houston’s rain and humidity, and a poorly seated gasket is exactly how keypads die in the first place. What you can safely check: confirm the keypad has power, confirm the remotes still work, and note whether the failure happens with every button or just some. That diagnostic information saves us time and saves you money. If the answer points to a failed keypad or intercom module, call us at (346) 375-5416 and we’ll bring the part to you, same day, with the price in writing before we touch anything.

FAQs